A packet video/audio system using the asynchronous transfer mode technique

H. Jonathan Chao, Cesar A. Johnston, Lanny S. Smoot

Research output: Contribution to journalArticle

Abstract

A point-to-point packet transmission system which integrates a fixed-bit rate, PCM coded, NTSC quality video signal and two multiplexed audio channels has been prototyped. The system consists of an Assembler Interface Card (transmit end) and a Disassembler Interface Card (receive end). At the Assembler Interface Card service equipment is connected in a daisy-chained architecture. Information is integrated into a SONET-like Asynchronous Transfer Mode (ATM) data stream. At the Disassembler Interface Card incoming information is broadcast to each piece of receive service equipment. Only information addressed to the equipment is filtered out. Service clock information which is not carried by the network is recovered at the receive equipment by using a digital phase-locked loop.

Original languageEnglish (US)
Pages (from-to)97-105
Number of pages9
JournalIEEE Transactions on Consumer Electronics
Volume35
Issue number2
DOIs
StatePublished - May 1989

    Fingerprint

ASJC Scopus subject areas

  • Media Technology
  • Electrical and Electronic Engineering

Cite this